Overview
The semi-automatic flap disc machine produces abrasive flaps in a semi-automatic manner. This machine is an automatic equipment for flexible production of discs, but it needs to be made by workers to make the bottom and arrange the films, and then start the automatic production after quantifying the glue. Based on the advantages of high efficiency and low defective rate, it has become an ideal equipment that can significantly increase the economic efficiency of the factory and reduce the unnecessary loss of materials.
Performance Features
1. Semi-automatic flap disc machine has a high degree of automation, and a single person can complete the operation without complicated training.
2. The production efficiency of the machine is high, and each job can produce 8000-10000 pieces (10 hours), which can bring great economic benefits to the factory.
3. The equipment can maximize the use of materials; the adhesive and abrasive belt can be set freely.
4. After our optimization and adjustment, the machine has obtained a very low defective rate, close to zero percent. This not only effectively reduces material waste, but also makes the production process smoother.
Basic parameters
Basic specification | |||
Flap disc size |
Backing: φ75mm-φ180mm Flap width: 11mm-35mm |
Glue qty |
4-30g (±0.5g) |
Flap disc Type |
T27/T29 Single/Double flap |
Flap qty |
Can be put flap at any degree |
Backing |
Fiberglass, plastic |
Production capacity |
6000P/8H |
Power |
Panasonic servo motor |
Operator |
1 |
Power supply |
Pneumatic, Electric |
Voltage |
380V |
Glue pump |
280KG |
Installed power |
8KW |
Glue system |
Airtac cylinder, SMC Balance control valve |
Glue system size |
1100mm*560*1600mm |
Pressure |
0.6Mpa~0.8Mpa |
Main machine size |
1300mm*900mm*1400mm |
Photoelectric sensor |
Autonics |
Cylinder |
Airtac |
Magnetic switch |
Airtac |
Control panel |
Weinview |
Air switch |
CHINT |
Temp. controller |
OMRON |
Reducer |
Liming |
Bearing |
FAG |
Bearing |
NSK |
PLC |
DELTA |
Linear guide rail |
Hiwin |
Pneumatic component |
SMC |
Details
The Parts We Use:
Electric Box:
Our Packaging and Shipping:
The company provides a complete set of operation plan configurations according to customer needs, including professional guidance from design, installation, training, production, quality control, and testing.
Cooperation process
Planning and setting up and preparing for the work. The customer determines the mechanical display site, the site hardware, and the corrective actions.
Any questions about the flap disc machine, please chat with me.
http://www.hg-abrasive.com/